Читать книгу The Gun Digest Book of Rimfire Rifles Assembly/Disassembly онлайн

17 страница из 20

Disassembly:

1.

2.

3.

4.

Remove the sideplate toward the left. Proceed cautiously, as the left end of the hammer pivot rests in a small hole in the sideplate. If the plate is tight, it may have to be nudged from inside the magazine well and pried gently at the lower rear.

5

6.

7.

8.

9.

10.

11.

12.

13.

14.

15.

16.

17.

18.

Reassembly Tips:

When replacing the bolt and bolt spring assembly in the receiver, be sure the two springs are completely seated on the guide, and that the guide is horizontally oriented so the springs will not kink.

Before replacing the trigger in the receiver, swing the inside arm of the mainspring up to the rear and rest it on the inside of the receiver. When the trigger is in place, use a small screwdriver to lift the inner arm of the spring while inserting the spring base pin. Be sure the tip of the spring engages the groove in the pin.

1.

2.

3.

Chipmunk

Similar/Identical Pattern Guns

The same basic assembly/disassembly steps for the Chipmunk also apply to the following gun: